The classic – proven quality for mobile cutting

Benefits

• lower investment and operating costs
• Loading and picking up the cut scrap is possible from the same position, no complicated maneuvering of the excavator
• self-sufficient operation with integrated diesel generator
• Picking up and transporting with a hook lift vehicle or low loader
• No operator necessary as there is no pre-compression via the wing cover, the excavator driver only monitors the automatic operation
• Little space required compared to stationary scissors, approx. 3 x 6 m is sufficient
• No assembly and foundation costs necessary for operation
• no building permit as it is a mobile unit
• Horizontal cutting with knife carriages guided over a large area results in only minimal wear
• The forces introduced into the knife carriage during the cut are always introduced centrally to the center, no tilting forces
• All internal surfaces are lined with Hardox wear plates and therefore minimal wear
• The scrap is fed from above and the scrap slides automatically due to the movement of the pre-compressor.
• The cut scrap is pushed out the front
• Operating experiences through more than 130 container shears in use.

Areas of application

• Operation at scrap collection sites without a power connection
• as an additional unit to absorb capacity peaks on existing scrap shears
• for the pretreatment of scrap on shredders
• for processing scrap directly at the source
• as a cost-effective alternative to guillotine shears when using several container shears next to each other with a scrap handling device
• as a processing plant for contaminants from commercial waste that cannot be further processed in the shredder.